Project

General

Profile

Bug #9372

spot: curve shape size can be increased but not decreased

Added by Roman Lebedev almost 7 years ago. Updated over 6 years ago.

Status:
Fixed
Priority:
Low
Category:
-
Target version:
-
Start date:
04/14/2013
Due date:
% Done:

100%

Estimated time:
Affected Version:
git development version
System:
all
bitness:
64-bit
hardware architecture:
amd64/x86

Description

Create curve in spot module, place mouse in the centre of inner curve, rotate mouse wheel.
The curve will only increase in size (when rotating in appropriate direction), but will not decrease.

History

#1 Updated by Aldric Renaudin almost 7 years ago

hi,
seems to work fine here. but you may face with a limitation of the curve implementation : curve can be reduced until a certain level only. this "level" depend on points positions. To be sure this is not the problem, you can try to draw a very simple curve with just 3 points, to increase it a lot and try to decrease it.
thanks for the report.

#2 Updated by Roman Lebedev almost 7 years ago

Yes, this level is the problem.
But still, the minimal size of the curve seems to be a bit big.

#3 Updated by Aldric Renaudin over 6 years ago

  • % Done changed from 0 to 100
  • Status changed from New to Fixed

hi,
this should be fixed in master now.

Also available in: Atom PDF

Go to top