Project

General

Profile

Bug #9109

Crop and rotate does not respect shown aspect ratio when using on/off switch

Added by Markus Kanet almost 6 years ago. Updated over 5 years ago.

Status:
Triaged
Priority:
Low
Assignee:
-
Category:
Darkroom
Target version:
Start date:
12/02/2012
Due date:
% Done:

20%

Affected Version:
git development version
System:
Ubuntu
bitness:
64-bit
hardware architecture:
amd64/x86

Description

For the last image i was working on i used a 16:9 aspect to crop the image.
For the current image with this module not yet enabled the aspect value still shows 16:9. If i use the On/Off switch to enable Crop and rote to the current image, the aspect ratio 16:9 is not applied.

Either reset aspect to "image" by default if module is not enabled or apply the aspect as show in the module

screenshot_croprot.jpg - Screenshot (147 KB) Markus Kanet, 12/02/2012 12:30 PM

History

#1 Updated by Markus Kanet almost 6 years ago

Screenshot with Crop and Rotate enabled using the On/Off switch. The 16:9 aspect as show in the GUI was not applied.

#2 Updated by Simon Spannagel over 5 years ago

  • System set to Ubuntu
  • % Done changed from 0 to 20
  • Target version changed from Candidate for next patch release to 1.2.1
  • Status changed from New to Triaged

This is still valid.

Some rewording:
after using C&R and switching to the next image while leaving the module expanded, the parameter is still set to '16:9', but applying the module just does nothing wrt cropping - since not the shown but the standard parameters are applied.
Once you click on the module to give it focus it applies the selected parameters but not before.

Could there be a fast fix to make it into 1.2.1? I know it's a minor thing, but one of our several tiny UI glitches...

Also available in: Atom PDF