Project

General

Profile

Bug #12107

Graduated density → Controls

Added by Timur Davletshin almost 2 years ago. Updated almost 2 years ago.

Status:
Triaged
Priority:
Low
Assignee:
-
Category:
Darkroom
Target version:
-
Start date:
03/31/2018
Due date:
% Done:

20%

Estimated time:
Affected Version:
2.4.1
System:
Debian
bitness:
64-bit
hardware architecture:
amd64/x86

Description

1. Load any landscape oriented image
2. Crop it to portrait
3. Turn graduated density module on

Problem:

Tool handlers (little triangles) are off-screen. Still I can specify
degrees directly in module settings but I'd expect handlers to work.

Screenshots are in the attachment, I believe they are self-explanatory.

Step #1.jpg (207 KB) Step #1.jpg Timur Davletshin, 03/31/2018 01:38 PM
Step #2.jpg (185 KB) Step #2.jpg Timur Davletshin, 03/31/2018 01:38 PM
Step #3.jpg (232 KB) Step #3.jpg Timur Davletshin, 03/31/2018 01:38 PM

History

#1 Updated by Simon Raffeiner almost 2 years ago

I can confirm this. The graduated density module seems to make some "strange" assumptions about the viewport (e.g. when the viewport is higher than wide), and since it is not easy to zoom out far enough, it becomes quite hard to manipulate the controls in this case. If the whole graduated density "bar" is dragged around, it also changes its size depending on where in the image it is dragged to.

#2 Updated by Tobias Ellinghaus almost 2 years ago

  • % Done changed from 0 to 20
  • Status changed from New to Triaged

You can also draw a line with the right mouse button in the image. It's still a valid bug of course.

Also available in: Atom PDF

Go to top